Convert a Toy Piano to Work As a Midi Device and Use It With Synthesia

Goal of this project:
Convert a cheap toy piano to work as a midi device and use it with Synthesia (http://www.synthesiagame.com/)
Other programs that use midi inputs can also be used.

Approach:
The pushbuttons of the piano are used to make a simple pull-down circuit for the arduino mega. The arduino interprets the keystrokes and sends serial midi data to the pc. Then this data is send to a virtual midi port with “serial-midi converter”.

Convert a Toy Piano to Work As a Midi Device and Use It With Synthesia

This midi port is connected to Synthesia via “MIDI Yoke”. MIDI Yoke is a driver that creates virtual ports. Each port has an input and an output which are connected. With MIDI Yoke you can couple different midi programs without any physical hardware.

 

Step 1: Parts and Tools

Parts and Tools Convert a Toy Piano to Work As a Midi Device and Use It With Synthesia

List of the parts needed for this project:

– Toy piano
– Arduino mega (This project van also be done with an arduino uno but you should use an line decoder to expand your arduinos inputs.)
– Flat ribbon cable (from old pc)
– Connectors (1 for piano and 1 for arduino)

List of tools needed:

– Soldering iron
– Desoldering pump or wick
– Ohmmeter
– Hot glue or any other strong glue

Step 2: Hardware

Hardware Convert a Toy Piano to Work As a Midi Device and Use It With Synthesia

The pushbuttons of the piano keys are used to make simple pull down circuits. The internal pull-up resistors in the atmega IC are used so we don’t need extra external pull-up resistors.

– Open the toy piano and locate the pushbuttons corresponding to the piano keys.
– Check if all the buttons have a common line. This is the ground line.
– Locate and remove the main IC. Solder wires to all leads going to the buttons including the ground wire.
– Check you didn’t make any shorts while soldering. (ohmmeter)
– Solder the other ends to the connector for the flat ribbon cable.
– Make a cutout in the housing of the piano for the connector.
– Reassemble the piano.

For More Details: Convert a Toy Piano to Work As a Midi Device and Use It With Synthesia

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top