Being able to sense temperature is cool… But being able to read the temperature of an object without even touching it is simply awesome. The MLX90614 is a sensor that can do just that. By reading the infrared light coming off an object, this guy can sense between -95 and 720ºf (-70 to 382.2°C) with 17bit resolution. That’s 128X more precise than the Arduino’s ADC, and means this little guy can tell the difference between 25ºC and 25.02ºC without even coming in contact. (Though 17bits split between -70 and 382 should give us 0.0034ºC resolution).
I have had my eye on this guy ever since I saw it at Sparkfun, but never had a reason to get one. Then, looking around, the MLX90614 seemed to be giving some people a hard time when trying to connect it to their Arduino. So… we at bildr did what we do best, we bought one, and took some time to make your lives easier and get this running. This is an I2C device like many sensors we have talked about before, but unlike all the I2C sensors we have written about before this, the MLX90614 can’t use the wire library to communicate with it, so we will be using another library, also, unlike what we typically deal with, the MLX90614 is not on a breakout board, so it requires some pull-up resistors on both the data and clock lines (Typically, these are included on the board, we just don’t notice them.)
The standard wire library wasn’t working for people, so we will be using the i2cmaster library instead. To complicate things even more, the i2cmaster wont run on the Arduino out of the box, some files need to be renamed and changed, and an extra txt file is needed to get it working. But… because it is open-sourced I can make those changes, and redistribute it. So that’s what I’m going to do, I’m just giving it to you here in its working version to save you some time and headache. You will need to drop the library into your Arduino library folder for it to work, but we will get there.
As for hooking this up, on your Arduino (everything but the mega) SDA is on analog input pin 4, and SCL is on analog pin 5. On an [[Arduino mega]], SDA is digital 20, and SCL is digital 21. Look at the picture to see how it should be connected, but a 4.7KΩ [[resistor]] needs to be connected from SDA to 3.3V, and another one from SCL to 3.3V. I also have a .1uf [[capacitor]] between power and [[ground]] as stated in the data sheet, but I have seen others not use it, and I have tested it without and it still worked.
So, here is the code. Because it consists of many files, I am using bildr’s fancy bildrCode wrapper. This allows us to have wiki like control over many files for a single project – just like this. All this code does is output the temperature in both Celsius and Fahrenheit via serial. So open your serial monitor!
To make this code work, before you load the code, or even open the Arduino program, we need to place the “I2Cmaster” in your Arduino Library. If you don’t know where that is by default, Look to the right.
Once the I2CMaster folder is in there, you can just go ahead and open MLX90614.pde in your Arduino software, and upload it.
This is just such a cool sensor, and hopefully we saved you some time with is one. Let us know if you do anything with this guy, we would love to see it, and possible feature it on this very blog!
We want you to blog with us
bildr is looking for anyone interested in writing any sort of blog post for bildr. If you think you would like to help bildr by writing something, or have an idea for a post you think should be written, please contact us at firstname.lastname@example.org or let us know in the forum.
Source: MLX90614 IR Thermometer